EcoRenovator - View Single Post - tool to staple down aluminum heat spreaders?

Daox · 03-18-14, 09:57 AM

I just wanted to wrap up this thread. I ended up using the pneumatic stapler and it worked like a dream. I had to adjust the pressure down to ~40 psi to not shoot the staple clean through the aluminum and still have it go in all the way. This took a bit of trial and error, but it wasn't bad. After I got it set, it worked so nice.

03-18-14, 09:57 AM	#6
Daox Administrator Join Date: Aug 2008 Location: Germantown, WI Posts: 5,525 Thanks: 1,162 Thanked 374 Times in 305 Posts	I just wanted to wrap up this thread. I ended up using the pneumatic stapler and it worked like a dream. I had to adjust the pressure down to ~40 psi to not shoot the staple clean through the aluminum and still have it go in all the way. This took a bit of trial and error, but it wasn't bad. After I got it set, it worked so nice. __________________ Current project - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. & To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.