EcoRenovator - View Single Post - tool to staple down aluminum heat spreaders?

Daox · 12-28-13, 05:26 PM

I'm to the point where I am putting down the aluminum heat spreaders in my office hydronic floor. However, I just tried stapling them with my hammer stapler and it really isn't cutting it. I tried swinging it, and hitting it with a hammer, both give less than stellar results. I'm guessing the next step is going to a pneumatic stapler? I highly doubt my electric stapler will punch through the .02" aluminum. Any other ideas?

Looks like Gary from builditsolar uses a pneumatic stapler: $2000 Solar Space + Water Heating System: Staple Up Radiant Floor Heat

Here is what I've gotten so far.

12-28-13, 05:26 PM	#1
Daox Administrator Join Date: Aug 2008 Location: Germantown, WI Posts: 5,525 Thanks: 1,162 Thanked 374 Times in 305 Posts	tool to staple down aluminum heat spreaders? I'm to the point where I am putting down the aluminum heat spreaders in my office hydronic floor. However, I just tried stapling them with my hammer stapler and it really isn't cutting it. I tried swinging it, and hitting it with a hammer, both give less than stellar results. I'm guessing the next step is going to a pneumatic stapler? I highly doubt my electric stapler will punch through the .02" aluminum. Any other ideas? Looks like Gary from builditsolar uses a pneumatic stapler: $2000 Solar Space + Water Heating System: Staple Up Radiant Floor Heat Here is what I've gotten so far. Attached Images __________________ Current project - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. & To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.