I like how well the lights turned out, with your new transformer size it should fit in a deep switch box behind your light switch very nice. I agree with leave your normal house wiring in and transform at the switch box then 12 volts to switch and so on. I would think you could then also use ground from 110 side to switch. question about mounting leds, could you use the holes in the center and add stainless screws to hold them in place? What if you run a thin strip of aluminum under them between the leds and wood and if you are going to use the home wiring use the ground and mount to strip? this way the whole system is grounded all the way back to breaker box in case transformer fails or ect. maybe to much but I dont think it could hurt? Again very nice
|