EcoRenovator - View Single Post

pinballlooking · 02-24-20, 09:15 PM

I bought a 16 speed drill press no chuck.
It was $50 yesterday today they said $10.
At $10 it was the one for me.

It is 23 years old. I really bought it to make a plate steel top and put my mag drill on top of it.
I tried to do this with a newer harbor freight drill press but it was to weak to handle it.

It does not look like much but it should clean up and make a good mag drill stand.
It works fine it just needs a new chuck.

02-24-20, 09:15 PM	#1
pinballlooking Super Moderator Join Date: Jun 2013 Location: SC Posts: 2,923 Thanks: 172 Thanked 564 Times in 463 Posts	I bought a drill press today kind of. I bought a 16 speed drill press no chuck. It was $50 yesterday today they said $10. At $10 it was the one for me. It is 23 years old. I really bought it to make a plate steel top and put my mag drill on top of it. I tried to do this with a newer harbor freight drill press but it was to weak to handle it. It does not look like much but it should clean up and make a good mag drill stand. It works fine it just needs a new chuck. Attached Images __________________ Current project Aquaponics system , Passive Solar Greenhouse build To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Solar Install 12.5 Kwh- To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Mini Split installs - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. EV Chevy Volt - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Last edited by pinballlooking; 02-24-20 at 10:27 PM..