I'm enjoying this discussion!
Re Serto fittings, one thing I liked about them, in addition to not having to flare the tube, was the fact that the installation procedure simply calls to tighten 1 3/4 turns after hand tight for initial install - NO TORQUE WRENCH to fiddle with!
Re using propane for leak test and purge, I wasn't going to raise the temp to get 15Bar. To my mind, any reasonable pressure is good enough to leak test, the only advantage I see of a higher pressure is that it makes any leaks that much more obvious. I'm certainly not going to pressurize until it blows! If the tubing's holding 100-150 pounds, then it's not 'broken'... Plus, as you say, propane sounds like a real convenient purge.
Tom
|