View Single Post
Old 10-25-20, 11:51 AM   #22
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,756
Thanks: 161
Thanked 527 Times in 432 Posts
Default

I have been using it more than I thought I would. It is just fun to ride and I enjoy riding a lot more than I thought I would.


I soldered two pieces of copper across the mosfets. I am not really sure how much that will help but people that did the mod claimed it helps.


I went over a bunch of the solder joints and added a small amount of solder. I do believe this will help as some of the joints looked very questionable.

I added a resistor in parallel this should increase the current flow AMPS. (Shunt Mod)


I had to order an adapter for my measuring device. I need to find out the amp draw now then install the moded controller and measure the amp draw to know how much I increased it.
Attached Images
  
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
pinballlooking is offline   Reply With Quote