View Single Post
Old 02-14-16, 08:56 PM   #586
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
Default

I want to mount the new heat exchanger close to the fish tank so I can keep the closed loop short.
I have a one gallon expansion tank with an 8 Amp 12 dc pump.

Here are a couple options I have.
I can mount the fan at the top of the roof and have it blow the hot air down to the heat exchanger.
I can use a flexible duct or I can build a duct with OSB.
I could mount the fan at the heat exchanger and have it suck the air down through duct work.
Does anyway know if a car battery will work to run a 8amp 12 Volt dc motor with a small battery charger to top it back off at night.
So questions.
Is just the volume of the closed loop and a very small expansion tank enough for the closed loop?
Have the fan push or pull the air.
Flexible or ridged duct.


My pump is the UF1215

I have this to help purge the air
1/2" Brass Automatic Air Vent Valve High Temperature
Attached Images
   
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
pinballlooking is offline   Reply With Quote
The Following User Says Thank You to pinballlooking For This Useful Post:
ecomodded (09-28-17)