I put my 3D printer to work on my headlight motor. They are just small tabs the help keep the cover in place. I found the file to create these on the internet.
I put silicone on the cover to seal it up so it really should not need the tabs. But just in case they will keep the cover in place.
__________________
Current project Aquaponics system , Passive Solar Greenhouse build
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
Solar Install 12.5 Kwh- To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
Mini Split installs - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
EV Chevy Volt - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
|