IIRC, that chart indicates a
very long vacuum cycle if it's pretty cold.. Like it's going to be for a good while..
I do have a rather large loop in the bottom of the of the line-set. (right behind the unit).
Plus, I know there are a lot of little loops inside the indoor-unit.
Those two low parts of the loops could be holding a lot of POE lube..
Maybe I could hook up like I was going to nitrogen pressure test and
then crack the nut on the small line to bleed out the nitrogen and any oil that might be pushed along..
I've found a lot of info about converting from R22 to R410A,
Flushing Techniques For R-22 to R-410A Conversions
but nothing much about just cleaning out an R410A line set..