Found the little air tank down the basement, and a 1/4 flare that I may be able to use.
Hopefully this hardware and the Manifold will allow me to pressure test the line-set.
It's got dry Scuba air in it now, so I'm thinking about driving up to the paintball
shop and getting a fill (3000 psi) of nitrogen. Just to keep the O2 out of the mix.
If I pressurize and bleed down a few times, I just might get some good
'dilution' of any remaining
unwanted gases in the line-set, before I start the vac procedure.
I'm very familiar with using a valve to control HPA. I use my 300 bar
scuba tank to put air into my 200 bar air rifle. So getting the right
pressure into the line-set won't be a problem.
I just have to find out what pressure I want to use..
So, what do you guys think? Will it work?