EcoRenovator - View Single Post

buffalobillpatrick · 03-18-14, 09:32 PM

I found a Copeland secret decoder ring:
ZP24K5EPFV830
Z=scroll, P=R410a, 24=24Kbtu, K5=version, E=?, PFV=1phase,208/230V

I was saying that it's heavy for it's size!

ROBINAIR 18560 VALVE CORE REMOVER any good?

Is 50W enough for compressor heater? or a couple of them on a thermal snap
switch so as not to overheat, Of course turn off heater when compressor is on. I was thinking of wraping with reflectex but I'm unsure of how much the compressor relies of convection to cool itself?

Amazon.com: Como AC 220V 50W Taper Ceramic Emitter Heater Pet Reptile Heat Lamp White: Pet Supplies

So this is NEW list of components in order:

compressor -> vibration absorber -> 1/2" ACR -> thermal switch cutout (on exterior of pipe) -> condenser 1/2" port (top) -> condenser -> condenser large port (bottom) ->

1/2" ACR -> High pressuer cutout -> 1/2" ACR -> SLHX -> 1/2" ACR ->
service port -> filter/dryer (outlet down) -> sight glass ->

2T R22 external bulb TXV -> 1/2" ACR -> service port -> low pressure cutout ->

evaporator small port (bottom) -> evaporator -> evaporator large port (top) ->
3/4" ACR -> SLHX -> 3/4" ACR ->

sight glass -> large accumulator -> vibration absorber -> compressor

Is 1/2" ACR between TXV & evaporator big enough?

BBP

03-18-14, 09:32 PM	#170
buffalobillpatrick Master EcoRenovator Join Date: Mar 2014 Location: Florissant, Colorado Posts: 599 Thanks: 814 Thanked 59 Times in 55 Posts	I found a Copeland secret decoder ring: ZP24K5EPFV830 Z=scroll, P=R410a, 24=24Kbtu, K5=version, E=?, PFV=1phase,208/230V I was saying that it's heavy for it's size! ROBINAIR 18560 VALVE CORE REMOVER any good? Is 50W enough for compressor heater? or a couple of them on a thermal snap switch so as not to overheat, Of course turn off heater when compressor is on. I was thinking of wraping with reflectex but I'm unsure of how much the compressor relies of convection to cool itself? Amazon.com: Como AC 220V 50W Taper Ceramic Emitter Heater Pet Reptile Heat Lamp White: Pet Supplies So this is NEW list of components in order: compressor -> vibration absorber -> 1/2" ACR -> thermal switch cutout (on exterior of pipe) -> condenser 1/2" port (top) -> condenser -> condenser large port (bottom) -> 1/2" ACR -> High pressuer cutout -> 1/2" ACR -> SLHX -> 1/2" ACR -> service port -> filter/dryer (outlet down) -> sight glass -> 2T R22 external bulb TXV -> 1/2" ACR -> service port -> low pressure cutout -> evaporator small port (bottom) -> evaporator -> evaporator large port (top) -> 3/4" ACR -> SLHX -> 3/4" ACR -> sight glass -> large accumulator -> vibration absorber -> compressor Is 1/2" ACR between TXV & evaporator big enough? BBP Last edited by buffalobillpatrick; 03-30-14 at 08:20 PM..