I just bought on Ebay: New GEA flat plate HX ref./water, 40 Bar, 9 Ton. Use this for condenser?
A few days ago I bought on Ebay: New GEA flat plate HX ref./water, 30 Bar, 4.7 Ton. Use this for evaporator?
On the TXV selection, I dont know either HX restriction to flow on the ref. side, I would guess low, the water side is plenty big.
The high pressure cutout would go on the compressor output & the low pressure cutout on its input?
Do you think I should get flare or sweat for the wet line filter/dryer & TXV ?
BBP
Last edited by buffalobillpatrick; 05-25-14 at 12:20 PM..
|