EcoRenovator - View Single Post - Aquaponics System, Passive Solar Greenhouse build

pinballlooking · 12-30-16, 10:04 PM

My stainless steel heat exchanger developed a small leak. This heat exchanger only lasted a little over a year this is to short time for the cost.

I decided to go a different way. I saw a couple heat exchanger made out of Pex and they had been using them over five years. I decided to make similar one out of 100’ Pex.

I need to mount the temp controller in something. Right now I have the circulator pump plugged into a timer on 15 minutes off 15 minutes then the temp controller is set to 72 degrees with a 1 degree swing. This small Tankless heater has a 20 minute safety shut off. The timer keeps it running by resting it every 15min.

12-30-16, 10:04 PM	#766
pinballlooking Super Moderator Join Date: Jun 2013 Location: SC Posts: 2,923 Thanks: 172 Thanked 564 Times in 463 Posts	My stainless steel heat exchanger developed a small leak. This heat exchanger only lasted a little over a year this is to short time for the cost. I decided to go a different way. I saw a couple heat exchanger made out of Pex and they had been using them over five years. I decided to make similar one out of 100’ Pex. I need to mount the temp controller in something. Right now I have the circulator pump plugged into a timer on 15 minutes off 15 minutes then the temp controller is set to 72 degrees with a 1 degree swing. This small Tankless heater has a 20 minute safety shut off. The timer keeps it running by resting it every 15min. Attached Images __________________ Current project Aquaponics system , Passive Solar Greenhouse build To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Solar Install 12.5 Kwh- To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Mini Split installs - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. EV Chevy Volt - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Last edited by pinballlooking; 12-31-16 at 09:03 AM..