I finally have a spot cleaned out to put my plasma table. I still need to wire my new compressor and run its air lines. I wanted to be able to load the table with my tractor. This location should allow me to do this.
Here is 1/2" 3/8" and 1/4" mild steel cut.
__________________
Current project Aquaponics system , Passive Solar Greenhouse build
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
Solar Install 12.5 Kwh- To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
Mini Split installs - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
EV Chevy Volt - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
Last edited by pinballlooking; 12-17-19 at 08:46 PM..
|