EcoRenovator - View Single Post - I bought a Chinese plasma cutter 50Amp 120/240 Volt.

pinballlooking · 05-13-19, 03:05 PM

I know this is not comparing apples to apples but here is my first cut with my new plasma cutter.
I cut the same steel the guy that bought my old one had tested it on yesterday.

Top left 1/2" top right 1/8" steel. Botton is 3/8"

I need practice I am not very smooth but I am very happy with the speed and ease this cutting went.

05-13-19, 03:05 PM	#15
pinballlooking Super Moderator Join Date: Jun 2013 Location: SC Posts: 2,923 Thanks: 172 Thanked 564 Times in 463 Posts	I know this is not comparing apples to apples but here is my first cut with my new plasma cutter. I cut the same steel the guy that bought my old one had tested it on yesterday. Top left 1/2" top right 1/8" steel. Botton is 3/8" I need practice I am not very smooth but I am very happy with the speed and ease this cutting went. Attached Images __________________ Current project Aquaponics system , Passive Solar Greenhouse build To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Solar Install 12.5 Kwh- To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Mini Split installs - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. EV Chevy Volt - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Last edited by pinballlooking; 05-14-19 at 09:28 PM..