View Single Post
Old 10-17-20, 09:29 AM   #17
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
Default

Here is the controller. The mosfet's look like their 70 volt 80 amps from the datasheet. They should be able to handle more amps than stock.
The stock controller is a 18 amp controller.

There is a shunt resistor that limits R003 the amps.
If I replace it with a R002 it should give a nice boost power going up hills.

I also ordered a R005 to put in parallel that will take the finial value to .001875 This will give just a little more amps and be a simple to just solder it on top of the other one.

There are lots of people doing this type of mod out there.
Here is a good example.


http://www.bergerweb.net/xb500/shuntmod.shtml

This mod will not really increase top speed but should give more torque.
To increase top speed I need more voltage or a better motor.
I want more torque for hill climbing.











I am going to order a R002.
Attached Images
    
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Last edited by pinballlooking; 10-20-20 at 10:07 AM..
pinballlooking is offline   Reply With Quote
The Following User Says Thank You to pinballlooking For This Useful Post:
Daox (10-20-20)