Last night, I decided to try to bend the pig tails downwards.. Not an easy job.
I did not like the two lines touching each other. So, I took some scrap and made a little partition between them.
Started drilling right after an early breakfast. 3/4" plywood on top, 1/2" plywood sub-floor and a few inches of foam. Easy going.
Just had to push some insulation out of the way.
Insulation looked thicker. It might be 2 layers of paper-backed R-11.
Hung the wall mounting plate. Got it level to 1/2 degree.
Wife helped me hang the IDU.
The wiring terminals. 4 conductors. A 230V pair, 1 comm line and 1 chassis ground.
Uncovered.
Bolted down and wired up the ODU.
I powered up the system with the remote in 'Fan' mode. No smoke.
Fan mode worked okay.