View Single Post
Old 02-26-21, 09:22 AM   #14
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
Default

I want going to make one of these for my compressor. Why reinvent the wheel.
I ordered this last night. It will make adjusting the belts simple. It was 39.54 shipped.

It is made for my motor frame 184T


This is what it will replace. These two bent up rails.
Attached Images
  
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Last edited by pinballlooking; 02-26-21 at 11:39 AM..
pinballlooking is offline   Reply With Quote