EcoRenovator - View Single Post

pinballlooking · 01-21-18, 10:06 PM

The valves are lapped. The head is cleaned up and the block is cleaned up.
I got the valve springs and retainers cleaned up and ready to install.

Block before and after

Head

ECTS was very bad I have a new one but this this is in bad shape.
(Coolant temp sensor in the head) this will make the car run very bad.
I have a new brass replacement.

Parts to rebuild the dog bone motor mounts.

01-21-18, 10:06 PM	#46
pinballlooking Super Moderator Join Date: Jun 2013 Location: SC Posts: 2,923 Thanks: 172 Thanked 564 Times in 463 Posts	The valves are lapped. The head is cleaned up and the block is cleaned up. I got the valve springs and retainers cleaned up and ready to install. Block before and after Head ECTS was very bad I have a new one but this this is in bad shape. (Coolant temp sensor in the head) this will make the car run very bad. I have a new brass replacement. Parts to rebuild the dog bone motor mounts. Attached Images __________________ Current project Aquaponics system , Passive Solar Greenhouse build To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Solar Install 12.5 Kwh- To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Mini Split installs - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. EV Chevy Volt - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. Last edited by pinballlooking; 01-23-18 at 10:07 AM..