View Single Post
Old 08-05-20, 11:51 AM   #13
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,844
Thanks: 166
Thanked 541 Times in 444 Posts
Default

We finally have our sandblast cabinet Speed consistency that we need.
I added an ALC Abrasive pressure Blaster 90Lb blaster. This was expensive but it is USA made and it just works.
We are still using the same steel grit I bought in the last post. We have a vibrator motor mounted to the bottom blaster.
But we only use that when sifting with the screen to refill the blaster. It speeds up the process.
We have two LED flood lights and expanded metal to hold the parts. We added air hose to blow off media in the cabinet.
We have most the other mods people have done to the cabinets. Amazon gloves...
We have put over 255 parts through it this summer.

We are where we want to be I have stopped looking for a good used cabinet.

We have sold almost 100 steps so far.





Attached Images
   
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
pinballlooking is offline   Reply With Quote