EcoRenovator - View Single Post - Ductless Failure (Mitsubishi mini-split)

WyrTwister · 02-05-17, 02:59 PM

OK , so , I had it in my head wrong . So , the 2 copper tubes that stick out from the IDU are part of the evaporator coil piping ? Not spliced on to the evaporator tubes ?

That makes sense from the point of view of reducing the silver solder / braze joints . Reducing the potential points of failure .

Thanks , :-)

God bless
Wyr

02-05-17, 02:59 PM	#31
WyrTwister Master EcoRenovator Join Date: Jun 2013 Location: USA Posts: 543 Thanks: 6 Thanked 44 Times in 38 Posts	OK , so , I had it in my head wrong . So , the 2 copper tubes that stick out from the IDU are part of the evaporator coil piping ? Not spliced on to the evaporator tubes ? That makes sense from the point of view of reducing the silver solder / braze joints . Reducing the potential points of failure . Thanks , :-) God bless Wyr