EcoRenovator - View Single Post

RobbMeeX · 08-23-14, 10:52 PM

I'm back. Today I installed a fill valve in our predominant use toilet. It's been running for months now. I adjusted it once and didn't realize it was split in the side. I wrote a review of the new one in the review section.
I've been battling an outside unit that kept tripping the breaker. Took it apart and found a dirty original contactor and did the capacitor for good measure. Worked for two weeks but started tripping again. The breaker was staying at 107° (thanks ir thermometer). Pulled it and found a burnt wire. I cleaned it with sandpaper tonight and swapped the hot water breaker for the AC. Tomorrow I'll buy a replacement and cut and strip a fresh piece of wire. I feel so damn handy!

08-23-14, 10:52 PM	#9
RobbMeeX Eco OWNER!! Join Date: Jul 2012 Location: ATL Posts: 99 Thanks: 25 Thanked 7 Times in 6 Posts	I'm back. Today I installed a fill valve in our predominant use toilet. It's been running for months now. I adjusted it once and didn't realize it was split in the side. I wrote a review of the new one in the review section. I've been battling an outside unit that kept tripping the breaker. Took it apart and found a dirty original contactor and did the capacitor for good measure. Worked for two weeks but started tripping again. The breaker was staying at 107° (thanks ir thermometer). Pulled it and found a burnt wire. I cleaned it with sandpaper tonight and swapped the hot water breaker for the AC. Tomorrow I'll buy a replacement and cut and strip a fresh piece of wire. I feel so damn handy! __________________ In it for the money (savings)