View Single Post
Old 07-15-13, 02:38 PM   #6
peacmar
Lurking Renovator
 
Join Date: Jun 2011
Location: fond du lac, wi
Posts: 26
Thanks: 0
Thanked 5 Times in 5 Posts
Default

I most certainly will and have started a thread already but family constraints have made it hard to add any info lately. The basic explanation its that it's a down draft design with a dedicated secondary burn chamber and a three stage heat exchanger that resembles a modern high efficiency furnace. First rule is to burn as perfectly as possible, then extract every last bit of heat. I reach secondary combustion temps around 1800° on average leaving little matter behind. Only fine fly ash and very little of it.
peacmar is offline   Reply With Quote
The Following User Says Thank You to peacmar For This Useful Post:
Dave291973 (12-07-15)