View Single Post
Old 10-18-13, 10:51 PM   #9
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
Default

The other one was right handed so I am sure this one is also. This one is just so tight. I will get out my flare nut wrench tomorrow. I used two wrenches and it would not budge. I used a socket and a wrench it would not move.
I think I will have to heat this one to get it off.
The small one came off with the normal amount of pressure.

I just got two oversized patio blocks. I was planning on drilling holed through it and bolting the unit to them.

Yes I am using a premade flare nut line set.

I put some PB Blaster on it and I will let it sit overnight. Maybe I will have better luck in the morning.

Last edited by pinballlooking; 10-20-13 at 06:27 PM..
pinballlooking is offline   Reply With Quote