View Single Post
Old 11-03-12, 09:56 PM   #61
menaus2
Apprentice EcoRenovator
 
Join Date: Feb 2011
Location: Driftless Region, North America, Earth, Solar System, Orion Arm, Milky Way Galaxy,Virgo Supercluster
Posts: 116
Thanks: 13
Thanked 33 Times in 25 Posts
Default



Starting to attach the collector inlet pipes to the pumps. The ability to use leftover Pex-AL-Pex for a lot of these runs made everything much easier due to make all kinds of turns and hold the shape


A nice shot of all the piping going into and out of the tank.


Right collector finished and starting on the left. I used some of the flashing material leftover from the absorber fins to make a little "roof" over the right collector. The slope should keep rain and snow off.


Absorber run on the left collector. Spacing the runs got a little tricky towards the bottom but turned out fine. Cheap $1 spray paint was used on everything, I figured even under stagnation conditions it would never see temps high enough to make it worth considering high-temp paint.

menaus2 is offline   Reply With Quote