View Single Post
Old 01-18-20, 06:50 PM   #13
where2
DIY Geek
 
Join Date: Apr 2013
Location: Sunny Florida
Posts: 401
Thanks: 74
Thanked 83 Times in 73 Posts
Default

When you pull it out this next time, check the passages and high speed jet. I found using the fine wire from the inside of a twist tie (like you find on a loaf of bread) works well for poking through the varnish in the small passages.

Since I was dealing with a metal carb bowl layered with varnish this afternoon, I poured half a carb bowl of acetone in the bowl and sloshed it around for a few minutes. That dissolved the varnish quickly. I made sure not to get the acetone on any rubber parts including the tip of the float needle.
where2 is offline   Reply With Quote
The Following User Says Thank You to where2 For This Useful Post:
Daox (01-18-20)