View Single Post
Old 01-16-21, 10:55 AM   #3
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
Default

I drained a couple gallons of water out of it. the I ran fresh water into it until it came out clean.
I put a new pressure gauge on it clean out pressure switch Temp wired the motor.
It fired right up. I have it sitting a 100 psi now for a little while before I see if pressure switch is working.

The exit valve has a slow leak but so far everything is good.

Having a stacker lift sure makes draining much simpler.

I actually had it higher than this where I could just walk under it.

Here it is running.


It is hard to tell from this clip but it is not very loud.
I have to guard off until I clean it up.
Attached Images
 
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Last edited by pinballlooking; 01-17-21 at 05:25 AM..
pinballlooking is offline   Reply With Quote