View Single Post
Old 05-28-18, 02:27 PM   #1936
pr0cess0r
Lurking Renovator
 
Join Date: May 2018
Location: Quebec
Posts: 26
Thanks: 1
Thanked 0 Times in 0 Posts
Default

Hello, i did not read all the thread yet but im very impressed with all information there is in it. Thank you for sharing.

Im wondering did you ever thinked about using pool heat pump has a starting point for your project. curently im fixing one to heat my pool it have a vracked heat exchanger that im patching.

When fixing it looked how everything is working ans this machine have those sensor
outside air temp (groud loop water temp)
inlet water temp (hot water tank temp)
outlet temp(water temp returned to hot water tank)
water flow that can be used to make sure the unit only run when water pump work

it also use a 3 wire control start is standard and im sure its possible to use themostart or other deives to talk to this protocol.

also its made for cooling and heating alredy and alredy have one side setup for water.

my unit is 50 000 btu it mean it would take less time to heat the water not take more power.

Anyways i whas just wondering if this could make less problem to solve when building a new systeme.

Thak you for all your detail about A/C equipment maybe i will be able to extract r410 myself when replacing my heat exchanger if epoxy path dont hold to pressur heat and chemicals.
pr0cess0r is offline   Reply With Quote