EcoRenovator - View Single Post

Xringer · 12-08-10, 06:39 AM

This is the intro section.. Where we learn about the skills of others.

And, one never knows when he might need the metal working knowledge to install
a Picatinny Rail on a 10/22, when the existing tapped receiver holes are stripped.?.

Anyways, my next mill-drill job might be making some aluminum
terminal (like the ground strip in your breaker box) blocks that
will clamp onto LA battery terminals. (Are the 1/2" and tapered?)
I was thinking of some 1/4-20 holes for the fat wires and a couple of 10-32s
for the skinny wires.. I have a whole box of 10-32 set screws that might work..

Here's my drill-mill.. The stinkin Chinese vise is too small for woodworking!

12-08-10, 06:39 AM	#8
Xringer Lex Parsimoniae Join Date: Feb 2009 Location: Woburn, MA Posts: 4,918 Thanks: 114 Thanked 250 Times in 230 Posts	This is the intro section.. Where we learn about the skills of others. And, one never knows when he might need the metal working knowledge to install a Picatinny Rail on a 10/22, when the existing tapped receiver holes are stripped.?. Anyways, my next mill-drill job might be making some aluminum terminal (like the ground strip in your breaker box) blocks that will clamp onto LA battery terminals. (Are the 1/2" and tapered?) I was thinking of some 1/4-20 holes for the fat wires and a couple of 10-32s for the skinny wires.. I have a whole box of 10-32 set screws that might work.. Here's my drill-mill.. The stinkin Chinese vise is too small for woodworking!