View Single Post
Old 08-14-15, 03:13 PM   #14
nibs
Apprentice EcoRenovator
 
Join Date: Jun 2010
Posts: 197
Thanks: 1
Thanked 16 Times in 15 Posts
Default

The actuator is a 24V Linak off a hospital bed, the only electrics are a PM motor & the overload switch which is mechanicaly triggered. Not worried so much about the actuator going over voltage. concerned more about using a 12V marine batt in series with a bank of 4 t105's for the small load of the actuator, while continuing to use the GC batts for moving the tractor, and the 12V batt for the forklift winch. The only circuit at 36V will be the actuator which is momentary. Just wonderiing what the experts think of a bit of haywire electrics???
nibs is offline   Reply With Quote