Quote:
Originally Posted by Mikesolar
Well, here is the HP mostly brazed up. My fridgie friends warn me against having the unit indoors. I am not sure I believe them but I have my niece living close to the boiler room so I think I will put it outside anyway. There might be a bit too much noise.
The condenser will be placed indoors so I don't have any water outdoors and I will pressure test it with nitro to 400psi so there should be no possibility of a leak indoors. The Evap (on the left of the pic) is connected to a pump and then to a big air coil which will also have a solar thermal input. This will heat up the 1000L open tank shown in another post.
|
That is a beautiful job you did with that. Can I ask, Is that a receiver in the middle and what are the 4 small components on the left? Check valves? I'm curious how this project is going. Good work!