View Single Post
Old 05-08-17, 02:28 AM   #5
gb484
Lurking Renovator
 
Join Date: Mar 2014
Location: Nottingham
Posts: 13
Thanks: 1
Thanked 0 Times in 0 Posts
Default

Thanks for your very comprehensive and helpful reply which confirms our thoughts about not shelling out a load of money on a new pcb in case it gets fried, because the fault lies elsewhere. Will check again for anything that resembles a fuse downstream from the line feed (have not seen one so far) and try to post a photo. I think these units have a hard life, as one compressor serves two evaporators but I'm no expert. May try to salvage some parts for future projects before it goes to the dump. Many thanks again.
gb484 is offline   Reply With Quote