View Single Post
Old 08-23-14, 10:52 PM   #9
Join Date: Jul 2012
Location: ATL
Posts: 99
Thanks: 25
Thanked 7 Times in 6 Posts

I'm back. Today I installed a fill valve in our predominant use toilet. It's been running for months now. I adjusted it once and didn't realize it was split in the side. I wrote a review of the new one in the review section.
I've been battling an outside unit that kept tripping the breaker. Took it apart and found a dirty original contactor and did the capacitor for good measure. Worked for two weeks but started tripping again. The breaker was staying at 107 (thanks ir thermometer). Pulled it and found a burnt wire. I cleaned it with sandpaper tonight and swapped the hot water breaker for the AC. Tomorrow I'll buy a replacement and cut and strip a fresh piece of wire. I feel so damn handy!
In it for the money (savings)
RobbMeeX is offline   Reply With Quote