EcoRenovator - View Single Post

matic33 · 11-17-16, 01:55 AM

I only use it for heating. It could be used for cooling to but i have radiators installed. I use it for heating till outside temperature is about -5 then i start heating with pellets.

I have gree minisplit LOMO 70 indor unit: GWH24QE outdoor unit: K3DNB6G.

I get what I want from it. Water temperature is about 50 degrees which is enought for me.
I only have I problem with electronics outdoor unit wont work without indor unit.
So i had to connect indor controller. I placed intor heat exchange sensor at the end of condenser set room temperature to 30 degrees so that unit will not stop because of room temperature. When the water temperature get to 50 degrees i simply use thermostat to swich off power fro unit. It means that compressor work at full power all the time.

I am asking if there is some kind of comtroller to make uotdor unit work without indoor unit to get propre controls.

Matic

11-17-16, 01:55 AM	#3
matic33 Lurking Renovator Join Date: Nov 2016 Location: slovenia Posts: 4 Thanks: 0 Thanked 0 Times in 0 Posts	I only use it for heating. It could be used for cooling to but i have radiators installed. I use it for heating till outside temperature is about -5 then i start heating with pellets. I have gree minisplit LOMO 70 indor unit: GWH24QE outdoor unit: K3DNB6G. I get what I want from it. Water temperature is about 50 degrees which is enought for me. I only have I problem with electronics outdoor unit wont work without indor unit. So i had to connect indor controller. I placed intor heat exchange sensor at the end of condenser set room temperature to 30 degrees so that unit will not stop because of room temperature. When the water temperature get to 50 degrees i simply use thermostat to swich off power fro unit. It means that compressor work at full power all the time. I am asking if there is some kind of comtroller to make uotdor unit work without indoor unit to get propre controls. Matic