View Single Post
Old 03-11-19, 08:23 AM   #23
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
Default

I did a small change on the pin I take out on my QC. I welded a flag on the pin so you can get a hold of it to pull it out.



I took it out yesterday. It is working well.




I started my 16" bucket. The teeth will mount to 1/2" plate. The top sides and the back will be 3/8" steel. I have 4 teeth for it. I ran out of mig welding wire. Amazon just dropped off some more hopefully this weekend I will make more progress.






I did a little more work on it.
Attached Images
     
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Last edited by pinballlooking; 03-14-19 at 05:53 PM..
pinballlooking is offline   Reply With Quote
The Following User Says Thank You to pinballlooking For This Useful Post:
Daox (03-11-19)