View Single Post
Old 04-04-14, 09:06 AM   #1
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
Default M2 MakerGear 3D printer.

My M2 MakerGear 3D printer kit should be here Saturday. This is my first 3D printer so we are looking forward to getting it.

It's print area is 8" x 10" x 8" Build Area
"Typical layer heights are between 0.3mm and 0.1mm but sometimes go below 0.05mm"

M Series 3D Printers | MakerGear


I think I will setup a small work bench in the garage to put the printer on. I read the fumes printing ABS can be bad and it can take a very long time to print. The noise can stay out there.


Attached Images
 

Last edited by pinballlooking; 05-19-14 at 05:06 PM..
pinballlooking is offline   Reply With Quote