View Single Post
Old 02-15-14, 02:52 PM   #7
Servicetech
Apprentice EcoRenovator
 
Servicetech's Avatar
 
Join Date: Nov 2013
Location: Moore Oklahoma
Posts: 267
Thanks: 108
Thanked 23 Times in 21 Posts
Default

Quote:
Originally Posted by Quest View Post
T8 or not: my experiences with electronic ballasts has been extremely positive so far (been using them for over 15yrs now). This is mainly due to the following reasons:

(1) the lack of /need of pre-heater hookups. Electronic ballasts do not need pre-heating set up to create the pre-heating to prepare for the striking of the ionisation stage.

(2) no striker needed (usually comes as a form of a capacitor (round aluminium can with 2 legs, which creates a blue/purple arcing look inside the can when "striking" happens).

(3) more precise control of the current used than mag ballasts.

Because of all of these, electronic ballasts (run on high frequency), when done right, can make those tubes lasts extremely long...

It is not impossible for those typical T8 tubes to last >10,000hrs or more under average operational conditions.

Oh BTW: mag ballasts relies extensively on pre-heater hookups. If any of the pre-heater wiring inside the tube becomes open, the tube is essentially "toast" and cannot be used.
Electronic ballasts also eliminate the 60hz flicker which has been claimed to give some people headaches. The buzzing associated with magnetic ballast is gon also. I don't think even make the magnetic ballast anymore, raw material costs more than the boards in the electronic ballasts. Manufacturers are always trying to reduce the amout of raw material in thier products, have you noticed just about everything is lighter than it used to be?
Servicetech is offline   Reply With Quote