EcoRenovator - View Single Post

AC_Hacker · 05-16-12, 07:38 PM

MMT,

Phenomenal report!

I wish everyone reported so much useful detail.

So was there any noise issue? Sounds like you did your best to prevent it.

Also, do you happen to know what the feed temperature range is to your hydronic system? The temp to the floor & the temp from the floor? The reason I ask is that I am in the process of designing my floor and I am going for the lowest possible feed temp... it would be good to know what I should expect.

Thanks again, what you have written will benefit many people.

Best,

-AC

05-16-12, 07:38 PM	#227
AC_Hacker Supreme EcoRenovator Join Date: Mar 2009 Location: Portland, OR Posts: 4,004 Thanks: 303 Thanked 723 Times in 534 Posts	MMT, Phenomenal report! I wish everyone reported so much useful detail. So was there any noise issue? Sounds like you did your best to prevent it. Also, do you happen to know what the feed temperature range is to your hydronic system? The temp to the floor & the temp from the floor? The reason I ask is that I am in the process of designing my floor and I am going for the lowest possible feed temp... it would be good to know what I should expect. Thanks again, what you have written will benefit many people. Best, -AC __________________ I'm not an HVAC technician. In fact, I'm barely even a hacker...