The rubber seals on the heating elements in my 74 gallon tank started leaking first.
Then the large seal holding the HX coil joiner plates (for cleaning out the HX).
I guess the rubber wasn't rated to last under higher temps, it dried up and got brittle.
I've been thinking about a hot-air collector panel for my cold basement problem.
Saw some on Ebay for $1,000+ !!
If I try hot air, It's going to be a full DIY job..
__________________
My hobby is installing & trying to repair mini-splits
EPA 608 Type 1 Technician Certification ~ 5 lbs or less..
Last edited by Xringer; 02-19-13 at 05:25 PM..
|