View Single Post
Old 11-30-08, 12:48 PM   #15
dcb
Lurking Renovator
 
Join Date: Sep 2008
Posts: 23
Thanks: 0
Thanked 0 Times in 0 Posts
Default

They say the snow is coming so I dusted off the welder and sorted out the pully/motor arrangements.

The pulley was two pieces so I welded it at the seam, sort of, from the inside. First welding in many years.


Then I held the pulley on the motor with a bolt and adjusted the runout and knocked it straight within a few tries and deposited much welding wire Tricky welding, gotta focus on the shaft since it is so thick.



It should be mostly braces and alignment from here.
dcb is offline   Reply With Quote