View Single Post
Old 01-02-20, 09:52 AM   #21
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
Default

Here the table cutting ½” steel plate. I am making magnet holders for lifting steel plate with two 880 pound magnets to help load the table.
I need to level the table and I will be raising the water level once I level the table.

1/2" Thermal Dynamics 60i
https://youtu.be/-iMxUaujFP0



The 2" by 1/4 square tube will allow the magnets to be spread apart 4'.
Then it will go on my forks to make it for simpler loading thick steel plate.

Attached Images
 
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
pinballlooking is offline   Reply With Quote
The Following User Says Thank You to pinballlooking For This Useful Post:
Daox (01-02-20)