View Single Post
Old 04-05-21, 03:50 PM   #5
pinballlooking
Super Moderator
 
pinballlooking's Avatar
 
Join Date: Jun 2013
Location: SC
Posts: 2,923
Thanks: 172
Thanked 564 Times in 463 Posts
Default

I did not buy this forklift the seller was not honest with the issues it had.
It developed a bad leak on the mast cylinder it looked like that it would need rebuilt and rechromed.
This is about 1,400 at the cheapest shop I could find but the best shop also.
Then the steering he fixed he did a ½ axx job did not replace the bottom bearing and did not cut the grove for the snap ring.
Just tacked welded it. I would have to redo it all. Needed a new started switch everything on it needed adjust or fixed. It had a flat tire with the others were cut.
I am still looking at this point.

I am not sure why people are not honest about condition not like I would not notice when I looked at it. Pictures that were provided were very old.
__________________
Current project Aquaponics system , Passive Solar Greenhouse build

To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Solar Install 12.5 Kwh-
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Mini Split installs -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

EV Chevy Volt -
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.

Last edited by pinballlooking; 05-24-21 at 02:43 PM..
pinballlooking is offline   Reply With Quote
The Following 2 Users Say Thank You to pinballlooking For This Useful Post:
Daox (04-06-21), MetroMPG (04-26-21)