My motor mount came in. It fits the motor but the platform is not big enough. I will need to extend it to the pully side and back a little.
I think I will cut some ¼” plate to put under it.
Here is a good pully calculator.
https://www.blocklayer.com/pulley-belteng.aspx
My large pulley is 16” my small is 8” 5/16” motor is 1740 RPM that puts the pump right at 904 RPM.
I bought the single-phase motor with the same size shaft so I could use the original motor pully.
__________________
Current project Aquaponics system , Passive Solar Greenhouse build
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
Solar Install 12.5 Kwh- To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
Mini Split installs - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
EV Chevy Volt - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
Last edited by pinballlooking; 03-04-21 at 10:12 PM..
|