I drained a couple gallons of water out of it. the I ran fresh water into it until it came out clean.
I put a new pressure gauge on it clean out pressure switch Temp wired the motor.
It fired right up. I have it sitting a 100 psi now for a little while before I see if pressure switch is working.
The exit valve has a slow leak but so far everything is good.
Having a stacker lift sure makes draining much simpler.
I actually had it higher than this where I could just walk under it.
Here it is running.
It is hard to tell from this clip but it is not very loud.
I have to guard off until I clean it up.