I did a small change on the pin I take out on my QC. I welded a flag on the pin so you can get a hold of it to pull it out.
I took it out yesterday. It is working well.
I started my 16" bucket. The teeth will mount to 1/2" plate. The top sides and the back will be 3/8" steel. I have 4 teeth for it. I ran out of mig welding wire. Amazon just dropped off some more hopefully this weekend I will make more progress.
I did a little more work on it.
__________________
Current project Aquaponics system , Passive Solar Greenhouse build
To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
Solar Install 12.5 Kwh- To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
Mini Split installs - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
EV Chevy Volt - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.
Last edited by pinballlooking; 03-14-19 at 05:53 PM..
|