EcoRenovator - View Single Post - EcoRider

Daox · 11-04-09, 08:33 PM

Battery rack work continues. Here are a few pictures of the progress.

Here is the rack that will hold the two rear batteries. I cut the pieces but haven't done any welding yet as I am clean out of gas for the welder. It is made out of .75x.125 angle iron.

Here are the support braces. They are bolted to the frame up front with two bolts on each side. They are 1.5x.125 angle iron.

Put the fenders back on to test fit.

Throw a battery on it. Everything looks like it lines up very well.

Here is a lower profile shot. I will be adding braces going to the far extents of the rack to steady it.

11-04-09, 08:33 PM	#129
Daox Administrator Join Date: Aug 2008 Location: Germantown, WI Posts: 5,525 Thanks: 1,162 Thanked 374 Times in 305 Posts	Battery rack work continues. Here are a few pictures of the progress. Here is the rack that will hold the two rear batteries. I cut the pieces but haven't done any welding yet as I am clean out of gas for the welder. It is made out of .75x.125 angle iron. Here are the support braces. They are bolted to the frame up front with two bolts on each side. They are 1.5x.125 angle iron. Put the fenders back on to test fit. Throw a battery on it. Everything looks like it lines up very well. Here is a lower profile shot. I will be adding braces going to the far extents of the rack to steady it. __________________ Current project - To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts. & To view links or images in signatures your post count must be 0 or greater. You currently have 0 posts.