Forum: Tools
06-14-15, 12:19 AM
|
|
Replies: 13
Views: 22,845
|
|
Forum: The Billiards Room
02-04-11, 12:04 PM
|
|
Replies: 12
Views: 15,883
|
|
Forum: Geothermal & Heat Pumps
02-03-11, 04:57 PM
|
|
Replies: 645
Views: 737,699
That don't look so bad of a spot. Some nitrogen...
That don't look so bad of a spot. Some nitrogen and soapy water will confirm the leaky spot. You do need to use a purge gas while brazing anyhow. A inspection mirror works wonders too see completly...
|
|
Forum: Geothermal & Heat Pumps
02-03-11, 03:20 PM
|
|
Replies: 645
Views: 737,699
|
|
Forum: Geothermal & Heat Pumps
02-02-11, 11:47 PM
|
|
Replies: 645
Views: 737,699
Edit: Is this unit 120v or 240v......guess I...
Edit: Is this unit 120v or 240v......guess I should look up the model #.
I think mis-wiring reversing L1 and the neutral will let the unit run Ok but screws up the logic for the controller...
|
|
Forum: Conservation
01-31-11, 10:25 PM
|
|
Replies: 18
Views: 30,493
|
|
Forum: Conservation
01-31-11, 09:58 PM
|
|
Replies: 12
Views: 26,870
Xringer
I understand what your saying ,but...
Xringer
I understand what your saying ,but for short cycling to occur a poor or not well thought out control strategy had to be used. In even 20 seconds there is no way to heat the exchanger(Fire...
|
|
Forum: Wind Power
01-31-11, 08:14 PM
|
|
Replies: 28
Views: 39,101
|
|
Forum: Conservation
01-31-11, 06:00 PM
|
|
Replies: 12
Views: 26,870
HI cholcombe
The short cycling is usually...
HI cholcombe
The short cycling is usually caused by the heat anticiapitor inside the thermostat. It adds a small bit of heat to keep the thermostat from overshooting ,but it cools quickly ~< 1...
|
|
Forum: Conservation
01-28-11, 12:23 PM
|
|
Replies: 18
Views: 30,493
Hi Ben
Yep it was you I was refering too...
Hi Ben
Yep it was you I was refering too about the coal to gas conversion. I orginally wanted to post a link to another pdf file that actually gave a good explanation of combustion analysis. A lot...
|
|
Forum: Conservation
01-27-11, 09:09 PM
|
|
Replies: 18
Views: 30,493
My post was made to make DIY guys aware of the...
My post was made to make DIY guys aware of the combustion process and all the parameters that need to be known.(in the few threads I read it wasn't discused) I wanted to post another link that...
|
|
Forum: Conservation
01-27-11, 05:19 PM
|
|
Replies: 18
Views: 30,493
Derating boilers or furnaces,or seting them up...
Derating boilers or furnaces,or seting them up require a anaylsis of the combustion flue gases. You need to find someone with the proper equiptment.The PCA (portable combustion analyzer) directly...
|
