Plasma Cutter Track
 

I am think about making a plasma track cutter. Yes a CNC plasma table would be so sweet.
I think I can make a tracker pretty quick and pretty cheap.

For my projects 3' should be enough maybe 4' at most.

https://www.youtube.com/watch?v=sfcTTbaY_7Q


I think I will make this one this weekend. It is just a square made into a cutter guide.

Ultimate Plasma Cutting Straight-Edge
https://ecorenovator.org/forum/attac...1&d=1558022071
https://www.youtube.com/watch?v=nVLrAStPCa0&t=4s

What do you foresee using this on?

I am not sure I am going to make a track now. I really like the clean straight cuts you can make with it.

I am going to make the modified builders square one. I just bought a builder’s square to make it.

I have been using my new cutter and as long as I have a guide, I am doing a pretty good job cutting straight. I got a stand off that really helps.

https://ecorenovator.org/forum/attac...1&d=1558150043


I was using my plasma cutter tonight and my welder ground was connected but I thought it was my plasma cutter ground. (They look the same)
I was trying to cut ½ plate. It was not working very well at all. I messed my tip up. :( Then I saw my ground was not connected.
It cut so much better with the ground connected.:rolleyes:

Here is what I ended up making.
My old square was in very bad shape. I kept the new one I bought and cut up my old one.

https://ecorenovator.org/forum/attac...1&d=1558303543

https://ecorenovator.org/forum/attac...1&d=1558303543

This really helps in making quick straight cuts. Very cheap to make.