Foil Faced EPS Basement Window Insulation
Hey Gang! I decided to insulate my basement windows as they really were a glaring point of heat loss. I had at first wanted to use bubble wrap, but decided since I didn't have any on hand to go ahead with a different route. We don't really use the basement during the day anyway, so the light won't be missed. The basement is unfinished except for a rec room installed in the 60's or 70's. It's all wood paneled with a tile floor.
The windows are old aluminum single panes doubled up. I could feel the draft falling down from them in a little cold snap we're having. 3 of the 4 have heat shrink plastic installed and I can tell it's helping a bit as they have not frosted as much as the one that's not sealed up. http://ecorenovator.org/forum/member...ow-before.jpeg This is the before shot of a window with the heat shrink film on it. Still cold window frame. These frosted up at -30C or 22 below. http://ecorenovator.org/forum/member...dow-after.jpeg This is after I carefully cut the panel to size and caulked around it with silicone. I noticed an immediate difference. http://ecorenovator.org/forum/member...om-window.jpeg Here's the Rec Room Window. Also a big difference. We do hang out in this room for a little while each day so comfort factor will go up. They are very shiny with the insulation installed! I'll re hang the curtains in front of them and it won't be as noticeable. I may do this in an upstairs closet, as it's a closet! What the heck does it need a window for anyway? Looks. From the front street it looks nice. I'll have to figure out what to put between the insulation and the window so it'll still look nice. Then maybe our clothes won't be so cold to put on. |
Quote:
|
Part 2
Ok, I've been at this a few days now (maybe 4 hours total) and have wrapped up the basement windows. The window with the solar panel duct penetrations was the most difficult but with measure twice cut once mindset I did pretty well. I needed to shave 1/8" off of the top and one side of a duct. Second try fit perfect.
This window by far had the worst cold air infiltration. http://ecorenovator.org/forum/member...20-before.jpeg Before. Note frost buildup to the left of the ducts along window edge below centre. http://ecorenovator.org/forum/member...nsulation.jpeg After second test fit. Silicone is next. I needed to extend a cut to the left of the ducts to get enough 'give' to get over the ducts. I will cover this with aluminum tape. http://ecorenovator.org/forum/member...ct-detail.jpeg Detail around ducts. I will do a leak test in a few hours when there's a good skin on the silicone and see if there's any cracks I missed. |
All times are GMT -5. The time now is 08:40 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Ad Management by RedTyger