Plasma Cutter Track
3 Attachment(s)
I am think about making a plasma track cutter. Yes a CNC plasma table would be so sweet.
I think I can make a tracker pretty quick and pretty cheap. For my projects 3' should be enough maybe 4' at most. https://www.youtube.com/watch?v=sfcTTbaY_7Q I think I will make this one this weekend. It is just a square made into a cutter guide. Ultimate Plasma Cutting Straight-Edge https://ecorenovator.org/forum/attac...1&d=1558022071 https://www.youtube.com/watch?v=nVLrAStPCa0&t=4s |
What do you foresee using this on?
|
1 Attachment(s)
I am not sure I am going to make a track now. I really like the clean straight cuts you can make with it.
I am going to make the modified builders square one. I just bought a builder’s square to make it. I have been using my new cutter and as long as I have a guide, I am doing a pretty good job cutting straight. I got a stand off that really helps. https://ecorenovator.org/forum/attac...1&d=1558150043 I was using my plasma cutter tonight and my welder ground was connected but I thought it was my plasma cutter ground. (They look the same) I was trying to cut ½ plate. It was not working very well at all. I messed my tip up. :( Then I saw my ground was not connected. It cut so much better with the ground connected.:rolleyes: |
2 Attachment(s)
Here is what I ended up making.
My old square was in very bad shape. I kept the new one I bought and cut up my old one. https://ecorenovator.org/forum/attac...1&d=1558303543 https://ecorenovator.org/forum/attac...1&d=1558303543 This really helps in making quick straight cuts. Very cheap to make. |
All times are GMT -5. The time now is 11:32 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Ad Management by RedTyger